Mold Removal in Kenner, LA

Kenner was built fast, and it is aging on schedule

Most of Kenner went up inside a fairly narrow window. Whole streets were finished within a few years of each other, by the same builders, to the same spec. That was efficient at the time and it has an effect nobody planned for: the parts of those houses that wear out are reaching the end of their lives at roughly the same time.

We see it as a pattern rather than as individual jobs. Original ductwork that has been pulling apart at the joints for a decade. Flashing at a roof penetration that was fine for forty years and is not anymore. A water heater sitting in an attic above a hallway ceiling. None of these are dramatic failures. They are things that were installed once, worked for a long time, and were never revisited because nothing about them ever asked to be.

So the useful question in a Kenner house is not only what is growing. It is what in this house is the same age as the house, because that is usually where the water has been coming from.

What it costs here

Minimum $600 for a contained area. Most Kenner work runs $1,000 to $5,000. On houses of this era the single biggest thing that moves a job up that range is the ductwork — if the system has been distributing spores, a one-room problem stops being a one-room problem.

The figure goes in writing before work starts, and the visit that produces it is free.

Estimate your job →

Two calculators, published price ranges, and no email address required to see the answer.

The ductwork question

This deserves its own heading in Kenner because it changes the price and most people do not think to ask about it.

Duct runs in houses of this vintage are often original. Insulation on them degrades, joints separate, and a run passing through a hot attic sweats where it has lost its wrapping. Once mold establishes anywhere in that system, the air handler is not containing it — it is distributing it to every room the ductwork reaches, several times an hour, whenever the system runs.

That is why somebody can have a clean-looking house, no visible growth anywhere, and a persistent smell in four rooms at once. It is also the most common reason a Kenner quote comes in higher than the homeowner expected, so we check the system as part of the evaluation rather than discovering it halfway through the job.

What is putting water in the house

Beyond the ducts, the list is short and familiar: an air conditioner that cools without running long enough to dry the air, an attic that has stopped venting, a slow leak that has been quietly working for months, or a house closed up while nobody was in it.

It can be one thing. More often it is several adding up. What we actually find causing it →

How the work goes

Free evaluation, and we say so plainly if there is nothing to do. If there is, we trace the water first, put a scope and a price in writing for you to approve, contain the area so nothing we disturb reaches the rest of the house, then remove or treat and walk it with you at the end.

The full process, step by step →

Testing versus removal

Louisiana licenses mold assessment and mold remediation separately, and one company cannot legally hold both roles on the same property. We remediate. For air sampling or lab work we will refer you to an independent assessor, and that result is worth more precisely because they have nothing to sell you afterward.

What Louisiana law actually requires →

Common questions

How much does mold removal cost in Kenner?

Our minimum is $600. Small jobs generally run $1,000 to $2,500, medium jobs $2,500 to $5,000, and larger jobs start at $5,000. Most mold remediation in Louisiana falls between $1,000 and $5,000, and the evaluation that produces your number is free.

Does duct cleaning fix a mold problem?

It is part of the answer sometimes and the whole answer rarely. If mold is in the system, cleaning it matters — but if the reason it grew there has not been dealt with, you are on a schedule to do it again. We have a duct cleaning partner who takes at least 10% off for our customers, and we would still rather find out why the system was wet first.

There is a smell in several rooms but nothing visible. Where do we start?

With the air handler and the ducts, usually. A smell in multiple rooms at once, with nothing to see, is close to a signature for something in the system being distributed around the house. It is worth checking before anybody starts opening walls.

Is Kenner too far for you?

No. We work Jefferson Parish and the greater New Orleans area regularly. Ask about timing when you call and we will give you a straight answer about the week.

My house has never had a leak. Can I still have mold?

Yes, and it is common. Humidity alone will do it if the air conditioning is not actually drying the house, and in a slab house with original ducts there are several ways for moisture to arrive without anything ever dripping.

Do you charge for the evaluation?

No. Charging to show up is why people wait, and mold that waits does not stay the same size.

Around Kenner

We cover Jefferson Parish and the wider New Orleans area — Metairie, New Orleans — and across the lake to Slidell, Covington and the Northshore.

See the full service area →